Step 1: Measure and mark your wall - Measure the height and width of your wall and mark the center point using a pencil. Then, use your level to draw a straight line from the top of the wall to the bottom, passing through the center point. This line will serve as your guide when installing the tiles.

Step 2: Plan your tile layout - Lay out your tiles on a flat surface, arranging them in the pattern you desire. This will help you plan the placement of the tiles on the wall and avoid mistakes.

Step 3: Cut tiles to size - Using your utility Scissors and cutting board, cut the tiles to the appropriate size to fit around corners and edges.

You can use Dremel, Wet saw, Hand saw, Standard tile cutter as well to cut the tiles.

Step 4: Peel and stick - Starting at the bottom of the wall, peel off the backing of the first tile and carefully place it on the wall, following your guide line. Press the tile firmly against the wall, smoothing out any bubbles or wrinkles. Continue installing tiles, making sure to line them up properly and keeping the spacing consistent.

Additional installation tips

Tip 1: Trim tiles as needed - As you near the top of the wall, you may need to trim tiles to fit around outlets, light switches, or other obstacles. Use your utility knife and cutting board to make precise cuts.

Tip 2: Finish the edges - To finish the edges of the wall, use a straight edge to cut tiles to the appropriate size. Then, carefully place the tiles along the edges of the wall, trimming them as needed to fit.